How to change the abnormal sound of the brake? Xiang yuan answers for you

When the car brake abnormal sound, our subconscious will think the car is wrong, and then go to the 4S shop, repair shop detection, the general maintenance personnel is a "speech art" : your car brake system somewhere "broken", need to replace, fake "repair" two times, give you a new parts. But in fact, this may not be the case, under the far auto parts for a detailed introduction to the brake pad on the abnormal sound problem.

Most of the time, the abnormal sound of the brake is not because it has a big fault, but some small problems that can be solved quickly, even don't need to solve it will be good, if this is the case, there is no need to spend money.

"Small problem" type brake abnormal sound

1. Brake disc run-in period

No matter the new car brake or newly installed brake disc, in the early use of the state has not yet reached a relatively consistent with the brake shoe, when the brake, heavy brake may appear sharp abnormal sound, this is normal, do not worry too much, is not a fault. If you care, it is recommended that the owner of the car during the run-in try to avoid heavy brake, brake.

2. Rebrake continuously

Excessive use of the brakes for a short period of time or continuous heavy braking, the brake disc overheating, braking power reduction, is a "thermal attenuation". The specific manifestation of thermal attenuation is significantly weakened braking force, brake will appear sharp abnormal sound. These two cases are also the normal performance of brake thermal attenuation, not fault, when the thermal attenuation disappears, abnormal sound will disappear.

"Attention needed" brake abnormal sound

1. Metal particles appear on the brake pad

Some of the original brakes are still made of semi-metal materials, and wear can lead to uneven distribution of high-hardness metal particles. When they are spread across the brake pad, the abnormal sound between the metal particles and the brake disc begins.

Although there is no serious damage, wear a period of time metal particles will disappear, but after all, there are some bad effects on the brake disc, cherish the car owners, or choose to replace better brake pads.

2. Brake pads are overworn

The thickness of the warning iron on the brake pad will directly rub with the brake disc, resulting in abnormal noise. The noise was loud and belonged to the unbearable kind. At this time, it is the time to replace, not only to replace the noise is huge, disturbing, braking force will be greatly reduced, hidden dangers increase safety.

3. Brake disc is excessively worn

The metal edge of the brake disc will be in direct contact with the brake pad, resulting in a huge abnormal noise, which may cause severe body shaking and brake failure. It is recommended that the owner of the car regularly check the thickness of the brake disc, the change, do not wait for excessive wear to change, inappropriate.

4. Brake disc deformation

If the brake is accompanied by abnormal sound and shaking, most of the brake disc deformation, then the replacement or repair, depending on the deformation.

The above is about the brake abnormal sound analysis, only for your reference!

Longyao xiangyuan auto parts co., ltd. was founded in January 2010, covering an area of 20,000 square meters, located in no.12, A3 zone, gucheng industrial park, longyao county, xingtai city, hebei province. The main products of the company are: brake drum, wheel hub, brake disc, brake shoe and so on domestic, import automobile, semi-trailer, full trailer chassis accessories, the variety is complete, the quality is stable and reliable. The company not only establishes long-term and stable supporting cooperation with sinotruk, fuhua and other large vehicle manufacturers, but also exports its products to the Middle East, America, Europe, Africa and southeast Asia and is deeply trusted by customers. Welcome friends from all over the country to visit and negotiate!